What is Fuel Injector, Its Parts and Overhauling with Pressure testing

Fuel injector as name suggest, is the main component of the fuel injection system. The fuel pumped by the fuel pump, reaches the injector, and from here to the combustion spaces. The minute particles of fuel are made by this piece.
The spring setting is according to the manufacturer, at which the proper amount of fuel and atomization takes
place. Like all other machineries, it needs to be overhauled from time to time, to make sure that it works properly. Pictorial representation of how fuel injector looks like is also given.

Step by Step Fuel Injector Overhaul Procedure

Either you are overhauling the F.I of the main engine or generator engine; more or less the procedure remains the same.
 1) Remove the fuel injector from the unit. And after that, cover the hole, with some cloth, so that nothing goes inside the unit.
Below are the parts of fuel injector
Fuel Injector
 2) Put injector in bucket and take it to the workshop.
 3) Do the pressure test first, on the equipment provided on board. If it is satisfactory, then no need to overhaul it. In particular ship, opening pressure was 400 bar. If not, follow the below steps.
Below is the picture of injector lying after overhaul
picture of injector lying after overhaul, fuel injector
 4) Fix it in the vice to open the union nut in M.E injector and locking nut in case of auxiliary generators.
 5) Now turn the injector and slacken nozzle holding nut. For M.E, there is no such thing. As soon as you remove the union nut, you can take out the whole assembly.
 6) Remove nozzle and keep it safe, as this is the most important component of it.
Cleaning the injector sitting surface on cylinder head
Cleaning the injector sitting surface on cylinder head, fuel injector
7) Take out the intermediate spindle, needle valve. For M.E injectors Non-Return Valve, Thrust Spindle Parts, Thrust Foot, Spindle Guide and Fuel Nozzle are the main parts.
8) Put all of these in clean diesel, this helps in removing any black HFO sticking to the surface.
9)  Lapping of needle valve and nozzle sealing face needs to be done as per the requirement.
You might like to read: Checks in Engine Room in your rounds
10) In the nozzle Clean holes, check with go-no go gauge. If no go gauge gives positive reading, it’s time to change the nozzle assembly (this is the costliest part).
11) Assemble all the parts and Pressure test it.
12) In A.E injector we have spring tensioning nut at the top for changing the pressure setting. But for the
M.E, we have the washers. They are used to increase or decrease the desired pressure.

So this was all in this article. There might be slight change in the way people overhaul the injector, but general approach it this.

You Might Like to Read These Posts Too:

Ashish S

Hi there! Well I am not a writer, just writes what can help people-that's it. Interested in listening from you. Loves to talk about gadget, music, nerdy stuff and witty substance in the talks. A Good respect in heart- for web.

One thought on “What is Fuel Injector, Its Parts and Overhauling with Pressure testing

  • March 31, 2016 at 4:55 pm
    Permalink

    some of a good writes that i,ve visit. simple explanation and nice representation. thanks for the info.

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

Special Topics For You

Read these

Scavenge Space Inspection-What to Check and Import... This article deals in the information regarding the scavenge space inspection done on the marine diesel engines and what importance it holds. Scaven...
Engine Room Rounds Guide for Marine Engineer-Part ... Engine Room rounds if taken in proper manner, will save lot of time and also will be helpful in keeping all the machineries and parameter under cont...
error: Content is protected !!